05-25-2023 09:58 AM
Power light is on, disabled Auto Power Off but printer still goes offline over time, have to power cycle twice to make available, how can I resolve this so I can use printer when I'm away from it.
05-30-2023 02:10 PM
Hi,
You can try disabling the ipv6 setting on your printer. Please click HERE for the steps.
Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.
05-30-2023 02:22 PM
The menu is different on the G3270 but I think I found the setting, no way to see if ipv6 is off or on, I enabled/disabled & enable ipv4, again no way to tell if both are on or off.
I have found that if the PC is up & connected it will stay this way (so far...) but when off for extended periods I have to power cycle the printer (which is in standby mode) to have it online.
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.