07-30-2015 03:13 AM
On 7/27/2015 I posted a comment about the updated printer drivers for a Canon MX922 causing boot delays when the printer was not on when the computer booted. Boot times went from a normal 20 seconds to over 2 minutes. Instead of returning the next day to see replies, the comment was gone. Canon, that was a very bad idea. I have been doing computers since my first Apple II integer machine and involved in BBS, Forums and comment boards from the beginning. Because of your actions I will now post that you delete honest comments that cast a bad light on Canon in every forum where they are pertinent. I will post the truth but will try to cost you sales.
07-30-2015 08:28 AM
Hi, LeoScott!
Thanks for using the Canon Community Forums. Your post was not deleted; instead, it was moved to the correct category as your MX922 falls under the category of "Printer/Multifunction Support." You'll find your post right here.
We hope this helps!
11/20/2025: New firmware updates are available.
EOS R6 Mark III - Version 1.0.1
EOS R5 Mark II - Version 1.2.0
PowerShot G7 X Mark III - Version 1.4.0
PowerShot SX740 HS - Version 1.0.2
10/15/2025: New firmware updates are available.
Speedlite EL-5 - Version 1.2.0
Speedlite EL-1 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.2.0
07/24/2025: New firmware updates are available.
07/23/2025: New firmware updates are available.
7/17/2025: New firmware updates are available.
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.