01-23-2018 01:56 AM - edited 01-23-2018 02:04 AM
Hello, I have following problem when I control camera through EDSDK: if camera fails to shoot after EdsSendCommand, for example if autofocus fails, then it will return "device is busy" error for any subsequent commands. Is there any way to bring camera back to working state except for physically turning it off and on again?
01-23-2018 01:40 PM
I don't know if anyone can anser that, unless Canon chimes in.
01-23-2018 10:20 PM - edited 01-23-2018 10:20 PM
There is always a chance, that someone was working with canon sdk and found answer.
01-11-2019 11:17 AM - edited 01-11-2019 11:18 AM
Hello,
I have the same problem.
Do you know how resolve this ?
Thank you for your response.
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.