Canon Community

jongraphs · 07-01-2020

Hey everyone, Rookie question. I managed to get all the OSDs to not show on the canon c200. Now I can't get them to show again, and no menu shows up when I hit the menu button. Any ideas? Tried literally every button... is there a combination of butt...

jongraphs · 06-09-2020

Hello Cannon Community, My EOS 5D Mark ii HDMI ouput varies between showing clean HDMI output and showing OSD, depending on what device I connect it to. Essentially, on some devices the HDMI "Mirroring" function just isn't recognizing, so I get OSD. ...

jongraphs · 07-06-2020

Solution: Toggle to playback (Media) mode, then hit the menu button and OSDs will show. From there, go to "Monitoring Setup" and look for OSD Output, turn on. This truly was a rookie question.

jongraphs · 07-03-2020

Thanks. I tried the self-service resources. I’ll just give you a call on Monday.

jongraphs · 07-02-2020

Bump

jongraphs · 07-01-2020

What happens when you adjust the focus ring? Anything?

jongraphs · 06-18-2020

So I found out that my scaler is a model that does not support adjusting EDID information (to configure the input port to expect a certain resolution). I'm screwed.

Canon Community

User Statistics

User Activity

Rookie Question - Canon C200 OSD

EOS 5D Mark iii HDMI Output Varies between Clean and Showing OSD Depending on Connected Device

Re: Rookie Question - Canon C200 OSD

Re: Rookie Question - Canon C200 OSD

Re: Rookie Question - Canon C200 OSD

Re: EF-S 55-250mm f/4-5.6 IS STM No Image

Re: EOS 5D Mark iii HDMI Output Varies between Clean and Showing OSD Depending on Connected Device