06-29-2021 05:26 PM - last edited on 06-30-2021 08:13 AM by Stephen
Hi Hope someone can help I ma using the ST-e3-rt Trigger with 430 ex iii-rt and a 600ex, when i firen the trigger the 430 fire around a secound after the 600. I have turned off all groups except those that i am using as someone had previously suggested. The issue is the same when i fire from the camera or by using the test button. I am fairly new to this system so appologies if this is somthing obvious. I have previously used the same set up with no issues. any help would be greatly appreciated
06-29-2021 07:59 PM
You should start your own topic, but does it happen when you use the 430 by itself?
06-30-2021 02:45 AM
Sorry yes, but couldn't see how to start a new topic, and yes it does the same when fired on its own from he RT
06-30-2021 08:12 AM
I started a new topic for you. ☺
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
09/26/2023: New firmware updates are available.
CN-E45-135mm T 2.4 L F - Version 1.4.0
EOS 1DX Mark III - Version 1.8.0
08/18/2023: Canon EOS R5 C training series is released.
07/31/2023: New firmware updates are available.
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
PowerShot Elph 360HS - Version 1.1.0.0
PowerShot SX420 IS - Version 1.1.0.0
PowerShot 620 HS - Version 1.1.0.0
PowerShot SX720 HS - Version 1.1.0.0
PowerShot G1X Mark III - Version 1.1.0.0
PowerShot G7X Mark II - Version 1.2.0.0
PowerShot G9X Mark II - Version 1.1.0.0
03/30/2023: New firmware updates are available.
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.