06-29-2021
05:26 PM
- last edited on
06-30-2021
08:13 AM
by
Stephen
Hi Hope someone can help I ma using the ST-e3-rt Trigger with 430 ex iii-rt and a 600ex, when i firen the trigger the 430 fire around a secound after the 600. I have turned off all groups except those that i am using as someone had previously suggested. The issue is the same when i fire from the camera or by using the test button. I am fairly new to this system so appologies if this is somthing obvious. I have previously used the same set up with no issues. any help would be greatly appreciated
06-29-2021 07:59 PM
You should start your own topic, but does it happen when you use the 430 by itself?
06-30-2021 02:45 AM
Sorry yes, but couldn't see how to start a new topic, and yes it does the same when fired on its own from he RT
06-30-2021 08:12 AM
I started a new topic for you. ☺
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.