08-05-2024 05:28 AM - last edited on 08-06-2024 09:38 AM by Danny
Why doesn't the shutter speed in Canon R8 camera go higher than 200? Even though I set it to high speed in the camera settings and also synced it with the trigger and flash, I tried with the 6d ii camera and it worked, but it doesn't go up on the r8, my flash nicefoto 680c, trigger tx_c01
08-05-2024 01:07 PM
I think you have restricted the shutter speed with flash in your camera.
Please check the red menus in your camera and on the 3rd tab you will find External Speedlite settings. Select this and look at the Slow synchro settings. It is possible you have set the to 1/200 sec. (fixed), and if so this is the reason. This setting means that when flash is used the shutter speed will only be 1/200 and even with high speed sync enabled the limit is still active. You need to choose one of the other two options and then you can use high speed sync.
08-05-2024 01:37 PM
I did this too, but again my shutter speed doesn't go higher than 200, and this is really driving me crazy. I also updated the camera to the latest update
08-05-2024 02:12 PM
Is the camera in manual exposure mode M? If so can you switch off the flash trigger and set a shutter speed more faster than 1/200th, so maybe 1/500th? If you can, then switch the flash trigger back on. Make sure that the trigger indicates it is in high speed sync mode, and also the camera menu shows high speed sync. The shutter speed should remain at 1/500th when you half press the shutter.
If it still is a problem. Check the custom functions, it is possible to limit the shutter speed on the second page. But if you could set 1/500th then it's not that. Most likely that at that point that it's a trigger compatibility issue.
08-05-2024 02:20 PM
No, unfortunately, it is not possible. In normal mode, when the trigger is off, the shutter speed varies up to 4000. In manual mode, it can be changed but when the trigger is turned on, high speed is shown on the camera, trigger and flash, but it is not possible to increase the shutter speed above 200, in your opinion, Is it a trigger problem? What trigger do you suggest for this camera and flash?
09-01-2024 10:14 PM
👋 hey, I don't know why Canon trainers do not say that clearly. Although it's mentioned in the R8 manual as per the following link.
The Canon R8 at the opposite of the R6 or R5 whether you are looking at the mark 1 or mark 2, The R8 has a specific and physical difference: it has only an electronic shutter, and then a "partial curtain shutter".
Basically to save money, and also to not cannibalise the market of the R6, Canon has not implemented a full mechanical shutter.
The direct consequence of this: The maximum shutter speed achievable with that partial mechanical shutter, is maximum 1/200th of a second. As opposed to e.g. 1/8000th or the R6. Or many cameras even the Old timer 6D DSLR, has a full fledged mechanical shutter.
So as a consequence: you will not be able to use a flash at faster speeds than 1/200th. And the reason is that the electronic shutter does not synchronise well with the flash at high speeds, when in HSS mode.
The reason for this is that the electronic shutter actuation, is not quite as a create e.g. sub 100th of a sec order, as opposed to mechanical shutters actuation and sync being accurate down to really fast speeds.
So yes mechanical shutters are expensive to develop. Expensive to build, expensive to achieve high speed synchronisation with the flash. Etc. You get the idea...
Now it's easy to bypass that limitation, get similar results as HSS, typically overwhelming the ambient e.g. sunlight using the flash and typically achieve a darker background.
This is ABC of outdoors flash photography: using an ND filter to reduce the luminosity. This is another thing that I do not understand why official canon trainers as above do not even mention that? Really. I think I should apply for a job as a canon trainer I would do well...
1) buy an ND filter, fit it on your lens, or buy an EF adapter that allows inserting filter in between the lens and the sensor. The advantage here is that the filter will be used for all of your EF lenses. It will save you a ton of money and it's very handy as it's very close to the lens. E.g. filters can be interchanged and when using a circular polarising filter you can turn it very easily as it's close to the camera and not at the end of the lens but this is another topic...
2) most ND filters are also adjustable by spinning them around, So adjust the level of darkness, and then calibrate your flash power output, in your exposure settings, in order to achieve a dark background or else enable you to use your lens at full aperture in order to isolate your subject from the background when doing a portrait. You get the idea...
3) you will figure out that you no longer need to go above 200th of a second. And if you are a professional sport photographer and need a super fast flash synchronisation speed then just buy an R6 or the much cheaper 5D Mark 4. Those cameras will be great for fast action. Still cheaper way cheaper then a brand new R5 or R6.
So yes now you get the picture why the Canon R8 is called by many an amateur camera or semi pro: because it does not have a phone mechanical shutter, and because it has a single memory card slot, and because it does not have inbody stabilisation.
You get what you pay for however the R8, compared to the competition is so cheap and offer such good value for money, that personally I really don't care I prefer to invest the extra $2,000 necessary to get an R6 into a very good lens instead. In my opinion this is much better spent money when you are limited and like a professional which has a much bigger budget because it's the full-time work tool.
LAST BUT NOT LEAST
This one is really again such a shame that canon trainers on this forum cannot answer: there is a way to bypass the maximum limit of 200th of a second in the flash menu of the Canon R8:
https://support.usa.canon.com/kb/s/article/ART182354#Shooting-1_0180_5
you will be able to set your flash at a faster speed, if using an HSS speedlight and a HSS capable trigger like the Godox ones, however you have no guarantee that the synchronisation with your shutter will be perfect: This means that you might take a few shots in a row and the flash output won't be right. Just because the flash will fire slightly before or after. But I guess it can be a compromise especially if you're not doing professional photos or you have the opportunity to shoot many times to get one GOOD shot.
Here we go full circle, just go and try that maybe it will make you happy. Again if you are not doing spot photography just buy an ND filter is cheap enough and enable you to get the result that you want in terms of darkening the landscape or isolating your subject from the background using your maximum aperture on your lens that has cost you so much because it's a 2.8 or 1.4 lens and you really want to use that wide aperture, now that you've paid for it!
Kind regards good luck
Romain Sacchettini, amateur or semi pro photographer from France based in New Zealand. @rsacchettiniphoto facebook.com/rsphotoskye
09-01-2024 10:17 PM
Correcting the typo as above:
The shutter is not quite >>>as create<<<:
Not quite as>>> accurate<<<< in terms of the high sync speed.
08-05-2024 05:56 PM
What type of flash shoe is on the R8? You might need the need the Canon ED-E1 multifunction shoe adapter to use the older strobe.
08-05-2024 07:48 PM
I don't know much about this, can you introduce a trigger that can solve this problem?
08-05-2024 08:08 PM
Hi,
I thought this might have to do with electronic shutter? However, I don't know enough about older flashes. I'll ping Demetrius so we can get another set of eyes on this.
~Rick
Bay Area - CA
~R5 C (1.0.7.1) ~RF Trinity, ~RF 100 Macro, ~RF 100~400, ~RF 100~500, ~RF 200-800 +RF 1.4x TC, BG-R10, 430EX III-RT ~DxO PhotoLab Elite ~DaVinci Resolve ~ImageClass MF644Cdw/MF656Cdw ~Pixel 8 ~CarePaks Are Worth It
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.