11-28-2023 12:13 PM
I wanted to see if there was any way in post to take either CLOG-2 or WideDR footage and transform to EOS Standard, and if there's an official EOS Standard LUT anywhere. I tried creating custom LUTs using LUTCalc, but they all seemed to be way, way off.
On the R5 C, there is a "look file" under the EOS Standard picture profile settings, "LookFile_EOS_Standard.cube," but I can't figure out any way to get it out of the camera.
I like the look of EOS Standard, but would like to be able to put an EOS Standard LUT at the end of a chain so that I could tweak values from the wider dynamic range footage.
Thanks!
11-30-2023 07:39 PM
Hello NickL,
There is no means of copying the .cube file from the camera unfortunately. You may want to try creating the LUT using Blackmagic Design's DaVinci Resolve.
12-06-2023 08:06 AM
I have done that, multiple looks on multiple projects, multiple times. I’m never able to achieve the same look.
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.