12-03-2022 03:49 PM - last edited on 12-03-2022 03:58 PM by Danny
I'm using a Prograff 300, A new user. On my first test prints I had nice even borders, went to place borders all was good, Went to Borderless and getting a fine white border one one side and top, went back to basic borders, top and bottom fine, one side seems right and the other about 2/3rds less. Did I do something... by appearances all settings seem normal. A4, ProLuster, feeding from top.
Thanks for any Help
JV
12-03-2022 03:54 PM
Hi,
New User here with a Prograff 300. My first few test prints came out with perfect Borders both Black or White. When went to Borderless... (A4, Pro Luster) I am getting a thin white border on the side and top of the Print. When I returned to Borders.... one side is quite thinner than the rest. All settings appear to be normal. Any help would be appreciated.
Thanks in advance JV
12-03-2022 04:01 PM
You can adjust the amount of extension the printer applies to borderless printing in the printer driver.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.