11-12-2022 03:02 AM
imagePROGRAF PRO-1000 purchased in 2019 (used rarely) fails to load Pro Platinum paper in the top. It loads in the manual feed but the printer crashes mid-print. It powers off abruptly - no error is displayed, and it won't start again using the power button. The only way I can get it to boot following a crash is to disconnect the power lead and wait 10 minutes. After rebooting it behaves the same way. I can sometimes complete a simple document print on plain paper, but it still crashes after the print is finished.
11-12-2022 06:45 AM - edited 11-12-2022 06:45 AM
This sounds like a hardware issue. I'd open the device up and carefully inspect for any foreign debris. Next, I would remove its inks and printhead. then reseat and reinstall. If the behavior continues, you'll need to contact Canon for repair.
Bay Area - CA
~R5 C (22.214.171.124) ~RF Trinity, ~RF 100~400, ~RF 100~500, +RF 1.4x TC, +Canon Control Ring~6D2 (v1.1.1) Retiring ~EF Trinity, others ~DxO PhotoLab Elite ~Windows10/11 Pro ~EVGA RTX 3080Ti FTW3 Ultra ~ImageClass MF644Cdw ~Pixel6 ~CarePaks Are Worth It
03/02/2023: New Firmware Updates Are Available:EOS R7 - Version 1.3.0EOS R10 - Version 1.3.0
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.