03-23-2024 10:19 AM - last edited on 03-23-2024 10:22 AM by Arthur
Hi,
The power went out in my house and I cannot reconnect my prograf 1000 with my McBookPro. I have tried: uninstalling and reinstalling the printer driver, disconnecting the printer power cord from printer (after powering down), powering down and restarting the computer, checking for updates on the OS (Ventura 13.6.1), going through the wireless LAN setup again.
When I attempt to print, I get an error message with check your pinter's operation panel or remote UI. When I disconnected and reconnected the printer, it powered back on and printer panel said that the printer was not shut off properly (which was the same message after the power went off in the house.)
Advice?
Ruth
05-09-2024 02:24 PM
Hi,
I recommend reaching out to Canon support. You will need to register your Canon gear HERE to access additional support options.
We look forward to hearing from you.
12-15-2024 09:13 AM
Thanks Arthur. I did reach out and the issue was resolved.
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
EOS C500 Mark II - Version 1.1.3.1
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.5.0
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.