03-08-2014 04:29 AM
I purchased a PRO-1 this evening and started installing the printer.
I was very careful to follow each step, reading it twice and then performing it. I installed the ink tanks. Carefully removed the print head from the packaging, inserted it in the print head holder. The Joint Lever clicked closed without any fuss. Reassembled the Head Cover and closed the Top Cover.
The power light began flashing for a few moments, then the Yellow alarm light started flashing with the power light. I counted 10 flashes.
The instructions say to reseat the print head if the yellow light flashes. Nothing I do can get the print head back into position to reseat it. After an hour of frustration I power cycled it. This has obviously interupted the initial setup procedure and I'm not sure what to do at this point.
Any advice or help would be appreciated.
03-10-2014 02:18 PM
Canon's support solution is for me to return the printer to the store or take it to a repair shop 20 miles away.
I think I know what I'm going to do.
Very disappointed.
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.