08-15-2016 04:51 PM
I have a Cannon MX430 series printer. My router was changed and now when I try to print, I get error messages. I reset wireless lan setting on the printer but still unable to print. Any suggestions?
08-16-2016 09:17 AM
There are older threads that have encountered this same issue.
http://community.usa.canon.com/t5/Wireless-Networking/Set-up-wireless-on-MX430-printer/td-p/4915
You can find the support page for a MX432, where you download the instruction manual, by following the link below.
https://www.usa.canon.com/internet/portal/us/home/support/
11/20/2025: New firmware updates are available.
EOS R6 Mark III - Version 1.0.1
EOS R3 - Version 2.0.0
EOS R1 - Version 1.2.0
EOS R5 Mark II - Version 1.2.0
EOS R5 - Version 2.2.1
PowerShot G7 X Mark III - Version 1.4.0
PowerShot SX740 HS - Version 1.0.2
10/15/2025: New firmware updates are available.
Speedlite EL-5 - Version 1.2.0
Speedlite EL-1 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.2.0
07/24/2025: New firmware updates are available.
07/23/2025: New firmware updates are available.
EOS R5C - Version 1.1.1.1
EOS C80 - Version 1.0.3.1
7/17/2025: New firmware updates are available.
EOS R7 - Version 1.7.1
EOS R10 - Version 1.7.0
EOS R8 - Version 1.5.0
EOS R50 - Version 1.4.0
Powershot V10 - Version 1.4.0
Powershot V1 - Version 1.1.0
EOS R50V - Version 1.1.1
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
