12-24-2016 12:32 AM
I have a MG3600 which I'm trying to configure & it repeatedly creates it's own subnet rather than connecting to the existing wireless network. Not what I was expecting.
It occurs to me that I don't see anywhere in the documentation that there is even a capabilty to provide authentication for the existing network. Being able to seamlessly print from only my phone is not the outcome that I was expecting.
Did I buy the wrong device? Should I be fighting with CUPS instead?
12-26-2016 02:30 PM
Go to this link to find your printer's product support page.
www.usa.canon.com/internet/portal/us/home/support
You will find the Canon software for your printer, which you can install if you have not already done so. You will also find links to "wireless help", which can assist you in getting your device set up.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.