11-03-2013 04:36 AM
Ok, this is a little embarrasing. Purchased a Canon ipf510 in the US and had it shipped to Australia. Plugged it in and blew up the power board. Australia uses 240v power. Not sure if its only the power board which has been damaged but due to cost of the printer I feel its worth replacing the power supply and hope that this will solve the problem. Machine is not under warranty because it was shipped out of the US. Can anybody advise me on
a) the likelihood that the damage is limited to the power board
b) if the ipf510 has fuse protection in which case I can just replace the fuse
c) best way to source a replacement powerboard and likely cost
Thanks
03/18/2025: New firmware updates are available.
EOS R5 Mark II - Version 1.0.3
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
01/27/2025: New firmware updates are available.
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.