07-15-2020 01:24 PM
This may be a dumb question but I am perplexed. I want to scan a multi-page document from the feeder but on occassion need to feed the pages one at a time, not as a stack pre-loaded in feeder. How do I set the scanner to wait for each page that is manually fed into the feeder, click "scan next" and let me click "finished" when I'm truly done? I can do this from the platen but not with the feeder. What it current does is as soon as it detects an empty feeder, it assumes I'm done and completes the job.
Thanks
07-17-2020 01:29 PM
Hi dws2006.
When scanning multiple pages one at a time, you'll want to use the scanning bed. This should cause the scanning software to take one page at a time, and prompt you for the next. If you're unable to scan this way (such as paper size being too long), then you may need to scan the pages individually and then combine them into a single PDF page afterwards.
Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.