Canon Community Canon Community
 


Reply
Occasional Contributor
Posts: 21
Registered: ‎08-29-2016

Built-in Intervalometer trouble

This is a trouble with my 5D IV:

 

When I use the built-in intervalometer in any exposure mode (that I've attempted, anyway) the "mirror-UP" setting saved in my C3 custom settings is un-done - meaning I have to enable mirror-up and save to C3 again.  Why will it not just leave my settings alone?  I've tried to avoid this by going into M instead of using the intervalometer while in a Custom mode but when I go from M back to C3 the mirror up is un-done again.

 

My work-around is to plug in the old-fasioned intervalometer-on-a-cord - because IT's not such a hassle as using the new built in one!

 

What am I doing wrong?

 

A

Just because I don't pose with a camera to my eye doesn't mean I'm not a dork.
Respected Contributor
Posts: 1,076
Registered: ‎10-17-2012

Re: Built-in Intervalometer trouble

Aaron D, 

 

We understand that you've run into some trouble with the timer shooting on your EOS 5D Mark IV.  At this time we are not aware of a method to circumvent this issue. 

Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.
Honored Contributor
Posts: 5,558
Registered: ‎06-25-2014

Re: Built-in Intervalometer trouble

Sounds like a firmware bug.

Bob
Philadelphia, Pennsylvania USA
Frequent Contributor
Posts: 46
Registered: ‎12-14-2012

Re: Built-in Intervalometer trouble

This appears to be a design issue, not a bug.  My 6D Mark II has the built-in intervalometer but cannot be used with Mirror Lockup, programmed bulb exposure nor with the LENR (long exposure noise reduction) buffer.

 

all important features in astrophotography.   I will have to go back to the external intervalometer too.

 

sigh!

 

jim

Frequent Contributor
Posts: 46
Registered: ‎12-14-2012

Re: Built-in Intervalometer trouble

Tim, I think this is a design shortcoming in the 6D Mark II as well.  In astrophotography it would be important for the internal intervalometer to work with:

 

  1. mirror lockup with 2sec shutter delay
  2. programmed bulb long exposure
  3. the LENR buffer (3 exposures then 1 dark frame applied to all)

Magic Lantern Support’s 1 & 2 on the 6D Mark 1.  Would be nice for Canon to support this!!!

 

typical astronuse case is 100 images with 120sec exposure, mirror lockup on each with 2sec delay from lockup to exposure.  Then dark frames generated and subtracted every 3 exposures.

 

jim

powered by Lithium

LIKE US on Facebook FOLLOW US on Twitter WATCH US on YouTube CONNECT WITH US on Linkedin WATCH US on Vimeo FOLLOW US on Instagram SHOP CANON at the Canon Online Store
© Canon U.S.A., Inc.   |    Terms of Use   |    Privacy Statement