09-10-2020 09:48 PM
I can't figure out what I'm doing wrong but if I have AF+Eye Detect selected then eye detect works in Single Shot mode but doesn't in Servo mode on my R5? When I switch to Servo, the little square around the eye disappears. How can I set the camera to use eye detect with the focus in servo mode?
09-11-2020 01:07 AM
Try going into the menus and resetting the camera back to factory defaults.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.