09-22-2014 05:25 PM
Hey everyone. I have been researching everywhere. I am pretty sure I am staring at my AF-Assist beam and I have it turned on in the settings. But for the life of me no matter what setting I put it on it does not fire if that is the case.
I made sure I was in One Shot AF, Single Shot Drive.
I am not an amateur, but am baffled. Is it defective?
Thanks!
Mike
Solved! Go to Solution.
09-22-2014 05:34 PM
"AF assist beam" is poorly choosen in this case, although it's more of a general term. The camera uses the built in flash for AF assist, not a dedicated red/IR light like on flash units.
09-22-2014 05:34 PM
"AF assist beam" is poorly choosen in this case, although it's more of a general term. The camera uses the built in flash for AF assist, not a dedicated red/IR light like on flash units.
09-22-2014 05:37 PM
Oh ok I mean I see the flash spazzing out. That is a cheezy way of doing it. What is the litte yellow circle then off to the left of the flash?
Thanks so much for the reply.
I have purchased the Yongnuo YN622C-TX and that has an AF-Assist beam but it is a little high on the focal area.
Mike
09-22-2014 07:46 PM
Hi Mike,
The light to the left of the flash is the red-eye reduction / self timer lamp.
Cheers,
Bill
09-22-2014 11:44 PM
Ah ok thank you very much. I am feeling better now.
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
EOS C500 Mark II - Version 1.1.3.1
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.5.0
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.