12-31-2015 12:21 AM
Hi All,
I have a 3 year old Canon Rebel T4i camera. I have no issues till now. But today I had a noticed a strange behaviour with resected to selection of the shooting mode. I was shooting in the Auto (A+) mode and I was switching the shooting mode btwn auto and hand help shooting. I think, I had rotated the dial fast at one point of usuage. Then the camera is not going to either the auto or hand help portrait. The camera hung up for a while and then the aforementioned issue happened. After that even iif i select the Auto mode then the no flash mode which is next to it is displayed on the lcd and the camera acts as if it is selected. I am seeing on LCD that the next mode is selected as rotate the dial. Like this, some modes are not selectable like Priority, Handhelp portrait and Night time portrait. I suspect that firmware is corrupted as I have turned the dial very fast when taking the pictures. Please help to resolve this issue.
Thanks
12-31-2015 07:24 AM
Maybe you stripped the ridges on the dial. It doesn't rotate through 360 degrees on that camera. So now the position switch inside the camera is out of sync with the dial.
01-10-2016 06:59 PM
Thanks for your reply. I would probably go to Canon repair facility in NJ and get that fixed.
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.