09-17-2021 05:51 PM
09-17-2021 06:48 PM
Sounds like a dead sensor. Call Canon. There have been reports that they are replacing sensors because of an overheating problem.
09-18-2021 10:23 AM
That is what shows on the back LCD screen? I, too, think its done if it does. I doubt this is caused by the overheating fix Canon has offered though.
09-18-2021 01:44 PM
09-18-2021 04:14 PM
Here is the Canon service advisory.
Most likely not your problem. Repair required. Balance repair quote against cost of new body from a reliable source like Keh.com
09-19-2021 10:19 AM
"Not sure how it would get overheated?"
That was just a thought not a diagnosis. As a concern some 70D cameras have experienced. SOmetimes electronic gear just fails. When you get your estimate, remember another used but working 70D is around $350 to $400 bucks. Also, keep in mind a 70D has got to be nearing end of service life. Perhaps an upgrade in camera is a good notion at this point.
11/20/2025: New firmware updates are available.
EOS R6 Mark III - Version 1.0.1
EOS R5 Mark II - Version 1.2.0
PowerShot G7 X Mark III - Version 1.4.0
PowerShot SX740 HS - Version 1.0.2
10/15/2025: New firmware updates are available.
Speedlite EL-5 - Version 1.2.0
Speedlite EL-1 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.2.0
07/24/2025: New firmware updates are available.
07/23/2025: New firmware updates are available.
7/17/2025: New firmware updates are available.
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.