77D Wont turn on

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-08-2020 04:14 PM
Hey Canon Community!
I have an issue with my 77D
I shut it off for 5 min and then tried to turn it back on but it just doesn't !
Tried everything, checking batteries, cheking SD cards and all those small little clicks that are next to them. I changed lenses.
Nothing. Put in few different batteries - No reaction !
have seen 70 D problems and tried to fix them with their tutorials but nothing !
I read that it could me mother board that is dead but i hope you guys have some input !
Thanks and take care !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-08-2020 04:29 PM
Have you tried to turn it one without an SD card, or an attached lens. If you are using a 3rd party battery grip, then remove that, too, and try to forget where you left it.
If all else fails, then your camera may need service. Contact Canon at 1-800-OK-CANON.
"Enjoying photography since 1972."

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-08-2020 04:35 PM - edited 04-08-2020 04:35 PM
thanks for the fast response.
I took out my SD card and my lense, still no power 😕
i have only Canon lenses and i have normal bateries
i live in Denmark so not sure if that number can help 😄
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-08-2020 05:30 PM
@gintelis wrote:Hey Canon Community!
I have an issue with my 77D
I shut it off for 5 min and then tried to turn it back on but it just doesn't !
Tried everything, checking batteries, cheking SD cards and all those small little clicks that are next to them. I changed lenses.
Nothing. Put in few different batteries - No reaction !
have seen 70 D problems and tried to fix them with their tutorials but nothing !
I read that it could me mother board that is dead but i hope you guys have some input !
Thanks and take care !
A weak component on a circuit board is most likely to fail when the device is first turned on. Just sayin'.
Philadelphia, Pennsylvania USA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-09-2020 09:58 AM
"I read that it could me mother board that is dead but i hope you guys have some input !"
Don't know if it is the MB but I do know you need to send it to wherever the authorized Canon service center is in Denmark.
EOS 1D, EOS 1D MK IIn, EOS 1D MK III, EOS 1Ds MK III, EOS 1D MK IV and EOS 1DX and many lenses.
