04-09-2022 07:24 AM
Hi All,
When I turn on my printer I have "Support code 6000" displayed. The cartridge carriage is locked on the right hand side which may have been caused by me powering down before unplugging the printer.
I have partially disassembled the printer looking for any paper jams but the paper handling mechanisms looks very clean.
Whilst I had the printer in a partially disassembled state I managed to remove the cartridges, remove the printer head, clean the printer head, re-install the printer head and re-install the cartridges. I was not able to manually move the cartridge carriage though. It is locked fast on the right hand side. I did try to manually turn the cog that I think causes the carriage to be locked and unlocked but it would not budge.
I have also tried resetting the printer by holding various combinations of buttons down. That clears the display but when I power down and power up I continue to get the "Support code 6000" displayed.
Has anyone here managed to clear this problem where the problem was found to be something other than a paper jam?
Although it's old, the printer is in decent condition so I really would prefer to fix it rather than adding to the plastic mountain by buying a replacement.
Thanks in anticipation.
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.