09-05-2024
09:28 AM
- last edited on
09-05-2024
09:31 AM
by
James_C
Hi, wonder if anyone can help me i've noticed on my prints, that I'm getting some banding at the start of the print and at the end, but not as heavy at the start, I've run a clean on the print nozzles and the rollers.. but still the same, has anybody else come across this problem
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.