08-29-2021 04:22 PM
Is there a setting that allows for the operation panel to open automatically? I just purchased the TR8620 to replace an MX882 that was purchased about 10 years ago. The MX882 opened automattically when printing, seems odd that the TR8620 does not?
12/05/2024: New firmware updates are available.
EOS R1 - Version 1.0.1
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R5 - Version 2.1.0
EOS R6 - Version 1.9.0
EOS R3 - Version 1.8.0
EOS R7 - Version 1.6.0
EOS R10 - Version 1.6.0
EOS R6 Mark II - Version 1.5.0
EOS R8 - Version 1.4.0
EOS R50 - Version 1.3.0
EOS R100 - Version 1.1.0
Powershot V10 - Version 1.3.0
07/01/2024: New firmware updates are available.
CR-N700 - Version 1.4.0
CR-N500 - Version 1.5.0
CR-N300 - Version 1.5.0
CR-N100 - Version 1.1.0
CR-X300 - Version 1.3.0
RC-IP1000 - Version 1.1.0
