12-05-2022 10:25 AM - last edited on 12-06-2022 09:08 AM by Danny
I'm not sure if I am posting to the correct board. I have an old Pixma MG7720 printer I am trying to recycle. I would like to delete any memory stored on it but when I google this question, the instructions point to start at a Settings/Registration button which I cannot find on this model. The only settings button I have is under the Setup tab and the Management Settings and Data Management tabs are the next steps after Settings/Registration are no where to be found. Of course it's out of warranty so I cannot get any help from Canon. Thanking anyone that can help me in advance.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.