02-07-2016 07:14 PM
I just opened a new Canon Pixma MG3500. The warning light flashes, and I am not able to even power the printer on or off.
The only cord attached is the power cord.
I have removed all of the packaging tape and protective pieces named in the set up guide.
I have unplugged the unit for 10 minutes and tried again to the same result. I then went ahead and installed the ink cartridges and again plugged it in - same result.
There are no 'typical printer start up noises/gear sounds, etc' upon electrical connection.
Any ideas?
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.