07-14-2016 01:10 AM
Door where printout comes out stays open.
Tried to close it, re-powered, remove the papar tray: still stays poen
07-16-2016 01:42 PM
Hello.
Turn the printer off. Then check to see if there are any visible obstruction in the path that are keeping the door from closing properly.
If the issue persists, troubleshooting with our support group will be needed to narrow down the cause of your issue. Please contact our support group using the "Contact Us" link below for additional assistance.
This didn't answer your question or issue? Find more help at Contact Us.
07-21-2016 12:03 PM
Clearing the path did not fix the issue. Support suggested to take if for repair, which would cost more than a replacement printer.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.