11-09-2017 04:01 PM
I inadvertently caused my mx920 printer to fall off the 9 inch high platform it was on. The cover popped out of the socket on the right hand side and I can't get it to pop back in again so there is a 3/4 inch or so air gap on the right hand side. Left hand side looks OK. . Nothing looks damaged. There must be a certain way of doing this but I haven't found it yet. Please help. Thank you.
11-10-2017 11:11 AM
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.