Hi to all,
I have a problem with the Eos Utility Software.
I have the OS Windows 8, and I installed the last version of EOS Uility 2.12 compatibility with the new OS.
When I connect my EOS 5D MKIII or the 7D the EOS Utility not recognized the camera.
The drivers are installed , all the others programs works fine with the cameras.
Someone have a suggestion ?
Solved! Go to Solution.
On page 6 of the EOS utility Manual Ver 2 it states that on Windows 8 the EOS utility will not launch automatically when the camera is connected and turned on. I assume this would apply to Windows 10 also.
That has been my experience.
There is a suggestion on the next page on how to (hopefully) fix this. I tried it but it didn't work. YMMV
EDIT: I can't remember if it's mentioned earlier in this thread, but you should invoke EOS Utility 2.
My past troubles seemed to be similar (under W7).
My external USB-HD (WD20EARS...) driver destroyed the EOS driver.
Solution: Disconnect every external USB device, deinstall all related drivers and SW.
(Re-) Install step by step. After each step take a Windows Restore Point (so you can redo it).
First reinstall EOS driver.
Worked (and still does so) in my case. Good luck!
Microsoft surreptitiously upgraded my Windows 7 to 10, which I did not want. I ended up reinstalled Windows 7. Canon's EOS utility 2.14.20, however, crashed on launching. What I finally was able to get it to work was to install 2.14.01, which was supposed to be for Windows XP. Hope this may help someone.
same problem still exists:
my 5dsr is recognized normally as 5dsr on my usb2 ports. works fine with eos utility.
on the same machine on the usb 3 ports it is only recognized as MTP portable device by windows and does'nt work with eos utility.
tried all the suggested workarounds and fixes. no succes.
please fix the driver! otherwise the usb 3 plug is useless for me.