04-08-2020 04:32 PM
I'm running two R800s with a Tascam DR40 to capture external audio. I'm syncing all three feeds into Final Cut. The two pieces of footage sync up perfectly fine, however the DR40 audio loses sync by the 2 min mark. Typically, I'd see this with a sample rate issue (44.1 vs 48) but I can't find anywhere that shows what the R800 is recording audio at.
Camera footage is recorded at 1080P / 60P / 35 Mbps
Audio is a 192k bitrate MP3 file recorded at 48kHz.
Thoughts?
09/26/2023: New firmware updates are available.
CN-E45-135mm T 2.4 L F - Version 1.4.0
EOS 1DX Mark III - Version 1.8.0
EOS R6 Mark II - Version 1.2.0
08/18/2023: Canon EOS R5 C training series is released.
07/31/2023: New firmware updates are available.
05/31/2023: New firmware updates are available.
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
PowerShot Elph 360HS - Version 1.1.0.0
PowerShot SX420 IS - Version 1.1.0.0
PowerShot 620 HS - Version 1.1.0.0
PowerShot SX720 HS - Version 1.1.0.0
PowerShot G1X Mark III - Version 1.1.0.0
PowerShot G7X Mark II - Version 1.2.0.0
PowerShot G9X Mark II - Version 1.1.0.0
03/30/2023: New firmware updates are available.
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.