Canon Community

AMO1 · 01-29-2024

My Pixma Pro 100 displays Support Code 1683 as shown here:The ink tank actually has about 1/8 inch of ink visible. This is not the first time it has happened. What could be the cause of this phenomena? If memory serves me, the previous time was also ...

AMO1 · 10-22-2023

Today my R10 is behaving like it is in Servo AF mode even though it is set to one shot AF, This is a new problem that just started today. It happens no matter what lens I have attached. I have no RF lenses so always use the EF-R adapter.Has anyone el...

AMO1 · 02-18-2024

The problem is not an erroneous low ink error. The message says it is not able to detect the ink level. Since I have a way to work around the problem, I don't see a good reason to replace it at this time. It is well past the warranty expiration.

AMO1 · 02-09-2024

Yes. I only use Canon ink. Never any 3rd party and never refill.

AMO1 · 02-09-2024

Hi Arthur,Thanks for your reply. I can continue printing by pressing the Rusume/Cancel button for 5 seconds, however, this completely disables the ink level detection until a new ink tank is installed. This forces me to manually inspect the tank prio...

AMO1 · 10-22-2023

Thank you Wadizzle for your reply. It turns out that the behavior was a result of cockpit error. It seems that I had accidentally turned on AF Preview so the camera was doing exactly what it was supposed to do. I turned it off and now all is good.

AMO1 · 10-22-2023

The camera focuses on whatever I point the camera at even if my finger is not on the shutter button. The camera does not beep or turn the the AF point green If I defocus with the lens focus ring, it immediately refocuses. The behavior is the same wh...

Canon Community

User Statistics

User Activity

Pixma Pro 100 Support Code 1683

R10 stuck in Servo AF

Re: Pixma Pro 100 Support Code 1683

Re: Pixma Pro 100 Support Code 1683

Re: Pixma Pro 100 Support Code 1683

Re: R10 stuck in Servo AF

Re: R10 stuck in Servo AF