So, I've found what I guess is the "correct" solution to my problem 3) in this post, rather than using solution a). If you go to the C.Fn1 settings (orange tab with a camera with dots below), there is a setting "Speed from metering/ISO Auto". If you ...
I ended up finding this thread as I was having problems with Auto ISO on an R6 Mk II (with latest firmware installed). My problems, at least some of which relate to this thread, were:1) In fully auto (green A+) mode, auto ISO would appear to work, bu...
I understand your comments, but as you say I'm just making suggestions that some people might find helpful.In fact, the lens I am using - Samyang/Rokinon XP 10mm f/3.5 - presents a particular difficulty. It is quite expensive, and is available only i...
Actually, you could probably combine (3) with (1) - but you'd have to apply the tape after you've closed the aperture on the "good" camera.Irritatingly (sort of), the lens works fine on an M5 using a 3rd-party EF to EF-M adapter, and on a Sony A6000 ...
Same problem with the Samyang 10mm XP on an R6 Mk II. Here are a couple of partial solutions that might help (at least if the lens has auto-aperture control but not auto-focus - I don't know if these work with an autofocus lens):1) Put some tape over...
