Canon Pixma MX490 powers on and goes through initialization, then powers back off. Keeps repeating the process as long as it's plugged in. Buttons are non-responsive.
I've updated my printer's firmware. I've followed the steps listed. It looks good until I send the first document to print - then it starts the loop all over again. This is the most disappointing experience I've ever had with Canon. I'm at the po...
I've installed the firmware update. I reconnected the printer and all looks good. I send a document to the printer, works fine. Send a second document - reverts to the reboot cycle again. This is beyond ridiculous.
