Takes up too much paper space.I tried that didn't work. Best thing is so far is lift up tray and pull to the left while pulling tray out.Works with out all the other tricks mentioned.
I tried that didn't work. Best thing is so far is lift up tray and pull to the left while pulling tray out.Works with out all the other tricks mentioned.
Outstanding.I've been doing a previous post by lifting bottom tray a little while and pulling to left. .It works but a little of a hassle.But I just did your trick. Happen to have scrap card board . And it works great!! How did you com across this id...
I had the same problem . With experimentation I've found the tray was binding a little. To make it a little easier I set the printer on 2x4s (flat) just clearing the tray on each side. It worked for me.Allows you to pull down easier with thumb on tra...
