Canon Community

dkoretz · 05-03-2024

The MBK part of my head is clogged. My bad: I make sure to print from time to time to prevent this, but it didn't occur to me to print in matte paper from time to time to protect against clogs.Two regular cleanings didn't work. I just did a deep clea...

dkoretz · 05-17-2023

One of the IS settings appears to have disappeared from the menus. On p. 309 of the manual, you get three steps for setting the still photo IS settings. Step 3 is "still photo IS", with choices "always" and "only for shot". I believe I set this for a...

dkoretz · 05-10-2023

I just got an R6 Mark II, my fifth Canon digital MILC. So far, it seems like a superb camera. However, unless I'm missing something--possible, since the options are so complex--the firmware is missing something obvious. On earlier models, one could a...

dkoretz · 03-18-2021

I've always read that the native print resolution of Canon printers is 300 dpi and have always set Adobe software to use that output value in printing with all of my Canon printers. However, I noticed that the specs for the prograf pro 1000 are 600 x...

dkoretz · 10-27-2020

I'm hoping somone with this printer is willing to test something. I have used the XPS (16 bit) driver with my Prograf Pro 1000 since I bought it two or three years ago, with no problems until last week. Last week colors were suddenly off. It looked l...

dkoretz · 12-16-2024

Deep cleaning and system cleaning are different. System cleaning is more extreme and uses more ink. I don't k now your printer, but if your printer has these, it should be in the manual, which you can find online. Again, your printer may be different...

dkoretz · 05-18-2024

@jrsforums: it seems to me that one can accomplish the same thing by printing a nozzle check from time to time. I don't print with Qimage. Doesn't Qimage require that the computer be left on to do this? I don't leave my computer equipment running whe...

dkoretz · 05-18-2024

@microprint: I think the problem is that printing doesn't necessarily use both inks. I was fine printing every few weeks, EXCEPT for MBK. I think the problem is that in practice, I hadn't used MBK for months, even though I had printed more frequently...

dkoretz · 05-11-2024

I don't. I just print from time to time.

dkoretz · 05-11-2024

I agree, it's important to have a plan to keep it clean, but I can do that fine with the software I usually use for printing, which is Lightroom. I've done this with a prograf 1000 for years with no problems at all. My mistake is forgetting about mat...

Canon Community

User Statistics

User Activity

imagePROGRAF PRO-1000 clogged head

EOS R6 Mark II IS settings unavailable

Firmware omission, R6 Mark II

Native print resolution Prograf Pro 1000

Prograf 1000 XPS driver problem

Re: imagePROGRAF PRO-1000 clogged head

Re: imagePROGRAF PRO-1000 clogged head

Re: imagePROGRAF PRO-1000 clogged head

Re: imagePROGRAF PRO-1000 clogged head

Re: imagePROGRAF PRO-1000 clogged head