I have the printer setup on one end of a table facing down the length of the table so that any longer prints just fall on to the table after they have gone past the tray. I have a cutting mat down there which doubles as a smooth surface for the print...
Can report back that I just printed my first panorama with it, I put the largest size paper it could handle through (or very close to) which was 43cm x 119cm. I printed it on hahnemuhle photo rag 308 that I cut from a 17" roll and fed it through the ...
Can I just confirm how you feed the printer such large paper sizes? Is it with the rear tray and do you have to manually hold it so it doesn't bend? Thanks!
