The camera blanks out at shutter speeds above 1/200sec below that its fine a bit of editing needed dont get any error codes and shutter has a count of 9191
Overnight ive noticed a barrel wobble on my lens just forward of af/mf and focus limiter switch? It hasn't been dropped or knocked . Ive seen the youtube video move the rubber focusing ring and tighten the screws BUT the screws are tight? it af focus...
When working fine it produces very sharp images but ive noticed that after a while the images go soft? Its not any of my lenses as they are pin sharp on my other camera. I looked on the internet and found an item Take the small cmos battery out leave...
i get this code every so often? i have turned camera off/on cleaned battery contacts? I noticed this only happens in bright light and go over 1/2550th sec shutter speed any suggestions can this be repaired/serviced in the uk AS Canon say there no par...
The camera was working fine as my backup camera THEN over night it wont focus in AF? Viefinder is sharp but photos blurred it has the same settings as my 1DS M11 so i dont know Does the CMOS Battery have any effect it hasn't been dropped or knocked ....
If i take a shot above1/200sec i get this if i enhance 100% i get this No image recorded . If i go down to 1/160sec f/16 28mm i get this image Then if i enhance 100% its ok i dont get any error codes?
If it's the 7D MK1 there's a simple solution i had the same problem..1. In menu settings go to the setting second from last (pic of a camera ) next to a white star green backgrounds Then scroll down to AUTOFOCUS/DRIVE....MICROADJUSTMENT..THEN PRESS ...
As i said all my lenses are working fine 70-200mm l usm f/2.8 100-400mm l usm 24-70mm f/2,8 i also have a IDS MK11 and 7D MK1 so i know it's not the lenses