05-13-2022 06:31 PM - edited 05-13-2022 06:32 PM
I use 2 Canon CR-N300 PTZ cameras in my house of worship. Content, power, and control are provided over Ethernet. I would like to use Http commands for basic control through a Loupedeck Live. I’m looking to control pan, tilt, zoom, focus, and iris with dials and preset selection with buttons. Buttons and dials can both be programmed with http command.
Is there a simple list of XC Protocol commands? I am on the developer network, but that is geared to people above my skill set. I am not looking to make a commercial app, just control my 2 cameras with something more responsive than OBS hot keys.
Take care and stay safe,
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 220.127.116.11
PowerShot SX420 IS - Version 18.104.22.168
PowerShot 620 HS - Version 22.214.171.124
PowerShot SX720 HS - Version 126.96.36.199
PowerShot G1X Mark III - Version 188.8.131.52
PowerShot G7X Mark II - Version 184.108.40.206
PowerShot G9X Mark II - Version 220.127.116.11
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.