08-16-2013 04:31 AM
hello everyone:
i'm struggling with couple things:
1) when using color munki & printing out a optimisation chart for a fine art paper i have to set the settings to fine art 30 or 35 and optimisation chart sometimes misses bit on end. if i shrink to fit it works but i am having issues with the fine art paper margins- the print is not sitting in the middle of the final outputted sheet for example---- can anyone advise here
2) canvas prints even though profiled look bland and nothing like the b9180 pro printer canvas i did
3) can someone recommend the settings i need from start to finish ie what printer paper colour calibration settings i need to avoid duplicate colour issues etc for my pro 1 particularly in the printer settings?
4)when i used colour tool pro on pro 1 i could scan charts with colormunki but it would not let printer accept them when i sent them to printer- this is for calibration of printer not making a profile...
these are complex questions canon helpline not always helping me so posting on forum .
thankyou so much
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
EOS C500 Mark II - Version 1.1.3.1
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.5.0
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.