10-27-2019 12:03 PM
I have tried several ways to print square (11x11") using my Pro-100 but each time the print comes out smaller, at approx. 7.5 x 7.5" I have tried this with both 12 x 12" and 13 x 19" paper loaded into the rear (top) feed.
My settings (in Lightroom) appear to be good for an 11.2x11.2" set-up. I have a template set up for 11.2 x 11.2 " printing. Also, I have checked on the paper size in page settings/print settings, and that seem to be set correctly as well. Does anyone have any suggestions as I am wasting a lot of photo paper!
10-27-2019 01:54 PM
These settings work fine for me.
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 188.8.131.52
PowerShot SX420 IS - Version 184.108.40.206
PowerShot 620 HS - Version 220.127.116.11
PowerShot SX720 HS - Version 18.104.22.168
PowerShot G1X Mark III - Version 22.214.171.124
PowerShot G7X Mark II - Version 126.96.36.199
PowerShot G9X Mark II - Version 188.8.131.52
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.