09-19-2017 11:51 AM
I noticed that if i print using Nikon NX with 19x13 with no boarder, it miss a whole line 13" long on print. All are at exact same spot.
I am priting from native file. not JPEG that created by NX. I don't test this case yet.
It doesn't do with Oly. so it is not printer heads. Diagnostic shows all fine too.
What causing this?
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.