01-29-2022 08:30 AM
I have recently run into a problem with my Canon Pro-1000. When running a nozzle check (image attached) the Photo Black seems to show some inconsistencies while the upright bars for each colour also seem to have issues.
Prints come out with significant banding of the black colours and the last 4-5cm of each print is always darker than the rest of it.
I have followed the guidelines of cleaning/deep cleaning etc but not had any luck with improvements.
Does anyone have any suggestions on what to try next to resolve the issue? Any ideas would be greatly appreciated!
01-31-2022 03:17 PM
Because performing multiple printhead cleanings did not resolve this issue, it is recommended that you contact one of Canon's Technical Support Representatives via phone or chat. To contact a Technical Support Representative, please use the link below:
03/02/2023: New Firmware Updates Are Available:EOS R7 - Version 1.3.0EOS R10 - Version 1.3.0
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.