01-20-2023 12:37 PM
I just purchased an imageCLASS MF743Cdw printer. When I try and go back to the previous menu item by pressing the back icon in the upper left corner of the screen, it selects the first item on the menu below the back icon. It seems that the screen needs to be calibrated. Is there a way to do that?
01-28-2023 07:21 AM
I had the same. If you go into service menu you can recalibrate it. There are a couple of hidden buttons either side of the home button. So procedure is:
Press "Button" 1 (left of Home)
Press "Button" 2 (right of Home)
Press sound button on left of panel
Press bottom right hand "button" on screen (can't remember what it's called!)
That should put you in Service Mode - but may take a few attempts. There's better visual instructions on the web 🙂
Once in it's Copier>Adjust>Panel>Touchchk, press on the dots, and it recalibrates the touch side of it.
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 184.108.40.206
PowerShot SX420 IS - Version 220.127.116.11
PowerShot 620 HS - Version 18.104.22.168
PowerShot SX720 HS - Version 22.214.171.124
PowerShot G1X Mark III - Version 126.96.36.199
PowerShot G7X Mark II - Version 188.8.131.52
PowerShot G9X Mark II - Version 184.108.40.206
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.