05-25-2014 04:15 PM
Just got a previously loved Canoscan LiDE 600F, to scan, and print some of these old negatives. I also upgraded to Win 7 Pro 32 bit system. Of course there was no software with the scanner, but got enough downloaded to finally get the flatbed part to work, but can't seem to get the negative scanning part to work. I can actually scan the negative holder. Can someone maybe point me the right direction to get this negative scanner going? I've already got a job for a wall mural, pending getting this scanner to work.
Thanks
Mike
New to the Canon forum, but long time member of POTN
07-09-2014 08:08 AM
Hi mojographics,
For information on positioning and scanning film, please click on the link below:
Scanning Film using the CanoScan LiDE 600F
Hope this helps!
This didn't answer your question or issue? Please call or email us at one of the methods on the Contact Us page for further assistance.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.