03-16-2018 08:53 PM
Hi, first time poster, here, so be gentle, please.
I'm using WIndows 10 and just purchased a CanoScan LiDE 220 to replace my CanoScan LiDE 100.
Now, my 100 was capable of scanning at 1600 dpi and while the software was unweildy, I figured it out.
When I purchased the 220, all the specs (including on the Canon website), indicated that this unit was capable of 4800 x 4800 dpi output.
So far, using teh included software, this has proven to be untrue.
I've seen elsewhere where it's been indicated that a Mac would be able to type in up to an output level of 19200, but nothing indicating that doing so in Windows 10 (or even half the advertised level, 2400 dpi) is at all possible.
I'd be happy with even 1600 dpi. Unfortunately, when I type that in under ScanGear in the Advanced section, it won't even scan a 7 x 10 color image at that level and gives an error message indicating:
"Scanning cannot be performed unless the crop size, output size or output resolution is reduced to 10208 x 14032 pixels or less."
So, this is totally freaky, because for the size of image I'm trying to scan, that's not even 1000 dpi.
That all said, I think it's time to either give up on this scanner and buy one that does what it says it can do, or find an open-sourced software that can get the performance out of this scanner that it should be delivering.
Let me know - thanks!
05-04-2018 02:50 PM
Please try these steps:
1. Click on the Windows Start button in the lower left hand corner.
2. Click on the Canon Utilities folder and then the IJ Scan Utility.
3. Click on the Settings button in the lower right hand corner.
4. Click on Scangear on the left hand side.
5. Place a check mark next to "Enable large image scans".
6. Click OK.
Please note, when this is enabled, the new limit will be 50000 pixels x 50000 pixels and 4.0 GB.
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 220.127.116.11
PowerShot SX420 IS - Version 18.104.22.168
PowerShot 620 HS - Version 22.214.171.124
PowerShot SX720 HS - Version 126.96.36.199
PowerShot G1X Mark III - Version 188.8.131.52
PowerShot G7X Mark II - Version 184.108.40.206
PowerShot G9X Mark II - Version 220.127.116.11
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.