11-25-2012 01:19 PM
11-26-2012 12:25 PM
The manual recommends using a blower when the automatic cleaning fails - or better yet, sending it to Canon for service. Sometimes - rarely - a blower will work and is the simplest and reasonably safe thing to use.
Otherwise many like the Sensor Swab solution. It is tedious and expensive, but I have used it effectively several times - especially on the 5D that seemed more prone to spots than the newer models. The problem I always have is going from bad to worse to finally better - a lot of patience is required and wasting or going through several of the swabs is not uncommon. Maybe my technique sucks, but I find it takes a lot of time and swabs to be eventually be satisfied. That said, I have never caused any damage and I have always managed to finally get the sensor clean. Along with the swabs, good lighting and magnification (reading glasses or similar) is also necessary as the spots that look huge on a photo will be nearly invisible.
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 184.108.40.206
PowerShot SX420 IS - Version 220.127.116.11
PowerShot 620 HS - Version 18.104.22.168
PowerShot SX720 HS - Version 22.214.171.124
PowerShot G1X Mark III - Version 126.96.36.199
PowerShot G7X Mark II - Version 188.8.131.52
PowerShot G9X Mark II - Version 184.108.40.206
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.