10-18-2015 11:04 PM
I'm learning to operate my T5i It's taking too long to snap a picture. With autofocus and the stabilizer ON. Mode set to P.
I press the shutter release half way, it focuses and beeps, I fully depress the release, the mirror comes up, it takes about four seconds before it takes the picture. It beeps and the orange light (facing the subject) comes on during the delay. Then the morror comes back up.
Do I have it in a mode that causes this? What is it doing before it captures the image?
Solved! Go to Solution.
10-20-2015 11:00 PM
Now it sounds like you've set it to MIRROR LOCK UP or SENSOR CLEAN. Try a full reset to factory specs.
10-19-2015 08:44 AM
Sounds like you have set it in timer mode.
10-20-2015 10:33 PM
Well, it was set for 2 sec. self timer.
I set it to Single shooting.
Now the mirror comes up, delays for 30 sec. and the mirror comes down, no pic.
I'm in P mode. The book says to hold the release half way untilthe focus dot appears and the speed and aperature don't blink. They don't so I press and 30 sec. later no pic.
I get pics in A mode.
So why does it not work in P mode?
10-20-2015 11:00 PM
Now it sounds like you've set it to MIRROR LOCK UP or SENSOR CLEAN. Try a full reset to factory specs.
10-21-2015 08:21 PM
Mirror lockup was enabled.
I remember now that the last time I used the camera (months ago) I was experimenting with time lapse. That's why "mirror lockup" was on.
I've got to spend more time with the new camera,
Thanks for the help
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.