08-05-2023
04:33 AM
- last edited on
08-05-2023
08:12 AM
by
Danny
Suddenly, when the camera is turned on, none of the buttons work!
Only the mode dial and the shutter are working,
I can't watch the playback and i can't open the menu, non of buttons are responding even the LCD screen
the battery fully charged and the MC formatted in the same camera and i replace the MC (I thought it was from a memory card)
what the issue any one face the same stuck
08-05-2023 10:38 AM
Was the camera dropped or did it get wet?
08-05-2023 04:39 PM
Remove the memory card, lens (re-install the body cap in its place), and remove any additional accessories (flash, etc.).
Then, remove the battery, let the camera sit for a while (a minute should suffice), re-insert the battery and power on.
Is the camera now functioning? If so, turn off, re-attach the lens and try again. If all still good, re-insert the memory card. Should probably reset the camera just in case too.
If the camera still doesn't function after these steps, contact Canon to see about having your camera repaired.
09/26/2023: New firmware updates are available.
CN-E45-135mm T 2.4 L F - Version 1.4.0
EOS 1DX Mark III - Version 1.8.0
EOS R6 Mark II - Version 1.2.0
08/18/2023: Canon EOS R5 C training series is released.
07/31/2023: New firmware updates are available.
05/31/2023: New firmware updates are available.
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
PowerShot Elph 360HS - Version 1.1.0.0
PowerShot SX420 IS - Version 1.1.0.0
PowerShot 620 HS - Version 1.1.0.0
PowerShot SX720 HS - Version 1.1.0.0
PowerShot G1X Mark III - Version 1.1.0.0
PowerShot G7X Mark II - Version 1.2.0.0
PowerShot G9X Mark II - Version 1.1.0.0
03/30/2023: New firmware updates are available.
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.