07-21-2015 01:58 PM
Hello
I have been working with Canon EF-S 18-55 NON IS lenes and have found a problem I can't seen to solve. The problem is that I do get auto focus but at certain points it will not focus. I have changed the board with a known good one, The motor assembly, The contacts with good looking ones from working units but not the contact strip as they look good.
The assembly moves freely with little resistance. I have also seen this problem on IS versions too but mainly on the non IS versions.
I'm looking for any other suggestion that might solve the problem.
Solved! Go to Solution.
09-01-2015 12:29 PM
03-06-2016 06:15 PM
Kathi,
Is this the lens you have? Canon EF-S 18-55mm f/3.5-5.6 IS II Lens. If it is I think you are better served buying a new one. They are $200 bucks and if you had the older model this one is better.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.